![]() ![]() At the entrance of Processing, a log from Jacob Temple reveals that he met his girlfriend Elizabeth Cross but couldn't find a single space worthy vessel in the bay so the two are also looking for a beacon. The Mining Sub Deck is offline according to Kendra so Isaac goes to the Processing Sub Deck while she tries to fix the problem however the elevator ride coincides with the arrival of several Necromorphs. Isaac passes through the RIG Room and calls an elevator in which a security officer dies of massive blood loss. She also says that the beacon is located on the Maintenance Sub Deck and that the asteroid has to be launched from the Control Room (which is locked and can only be opened by an Emergency Access Key on the Processing Sub Deck). ![]() Kendra tells him that there is an asteroid waiting to be smelted in the Mining Bay that he could attach the SOS beacon to and launch into space to make a clean broadcast. The Schematic is on the workbench on the left side of the room.After defeating The Leviathan in Chapter 6: Environmental Hazard, Isaac arrives at the Mining bay with a new goal - send out a distress call. Turn right, and then to your right, you’ll spot the Platform Storage door (we are not running in circles, I promise). After you run down the flight of stairs, you guessed it, go right again and through the Refueling Control Station door. Go through, then through Machine Shop door on your right. Go through the Engineering door, turn right at the “T” junction, then in the big room, turn right again and you’ll see the Preparation Room door. Security Clearance level two is required. Schematic Locations in Chapter 8 in Dead Space Remakeįound in the Refueling Station on the fourth floor. Located in the Equipment Workshop, sitting on a desk. The Schematic is on a coffee table when you walk in. You need to aim at the lock that’s inside the room, shoot it open, and then you can go back to the now unlocked door. Continue moving forward and you will soon see the windows of that locked room on your left. ![]() Proceed forward down the hallway and immediately turn left. A few seconds later, you will see a locked door on the left. From the Save Station, go across the Save Station icon and not down the path next to it. Schematic Locations in Chapter 7 in Dead Space Remakeįound in Deck “B” Processing (Mining), and it’s tricky as hell. When you enter the EVA Prep room, just walk forward and you will see the Schematic on the bench. ![]() Schematic Locations in Chapter 4 in Dead Space Remakeīefore completing “Calibrate Three ADS Cannons,” in the EVA Prep room (after you open the Exterior Access door, down the hallway and then to the right). The Schematic for Ripper Blades can be found inside on the floor. Minor Spoiler: Keep your aim at the floor when you open the door. When you exit the elevator that takes you down, go right and keep right until you end up at a door. The Ripper Blades Schematic is found in the Fuel Storage. In the Engine Room, climb up the stairs to reach the Primary Engine Panel (many screens are glowing here so it’s hard to miss it), and the Flamethrower Fuel Schematic will be sitting on the chair. Once you open it, you will see a couple of lockers ahead, where you’ll spot the Medium Med Pack Schematic. You need to look for a door that says “To Centrifuge” after the Decontamination Room section. Schematic Locations in Chapter 3 in Dead Space Remake ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |